These pictures show how LC Panels connect together. LC Connectors simply snap into place, and hold firmly. No tools needed. All connectors are made using heavy duty 1 1/4" x 1/8" steel flatbar for strength and a special plastic extrusion that will not scratch the panels

We have other connectors that are not listed here, for special connections.

Everything has been done to keep the overall cost of a LC Panel system down, while providing long lasting hardware.

With the variety of connectors avaliable, the panel configurations are endless. No other panel system is as versatile or inexpensive as an LC Panel system.

For help with connector selection, just fax a rough sketch of your intended layout to us, and we will fax back our recommendation.

Fax No. (951) 657 0180

Connectors, any design, just snap them in!
363 W 3rd St., Perris, CA 92570
(951) 940 6068 Business, (951) 657 0180 Facsimile
Email us!
Note: Any angle or connector design can be made. Cubicles don't have to be square
Angle Connectors-attaches two panels at an angle (90°) Since either panel can slide to overlap the other panel, "true corners" are easy to form when using the LC Angle connectors. $12.95 each
Straight Connectors-attaches two panels in a straight line (180°) $11.95 each
T-Connectors-attaches the end of one panel to the face of another panel, (anywhere along the face). These come is "upper" and "lower" models $12.95 each
LC Legs-can be snapped into place for a "stand alone" panel, one on each side. $12.95 each
Wall Connectors-Narrow type. Allows the attachment of our panel to a wall or other hard surface. $11.95 each
Wall Connectors-Wide type. These offer good lateral stability and are easy to install. This type of connector can also be used as a floor connector. $11.95 each
Straight Legs-This special connector connects two panels (at the bottom) in a straight line, and, at the same time, stabilizes like our "Leg". This is normally used between panels that comprise a long straight line of panels (4 or more). A regular "straight" is used at the top. In the 4-panel illustration (above right) we have a "Leg" on each end and a "Straight Leg" in the middle $15.95
Star Connectors- This connector makes a 4 panel intersection for panels as shown above. One connector is used below, and another on top. $15.95.
Stacker Star Connector- This connector makes a 4 panel intersection for "stacked" panels. Normally for trade show use, where 10'-12' + heights are desired. The illustration (above right) shows blue E-panels and smaller red panels, stacked with Stacker Star connectors and straight connectors. $18
High-Low 3-Way Connector- allows a shorter panel to be connected to two taller panels at a 90° angle as shown in the illustration (above right). A "T-Connector (lower)" is used at the bottom. $19.95
5 Way Star Connector- allows the intersection of 4 stacked panels and 5th panel at 90° as shown in above illustration. $23.95
Power Pole Star Connector-makes a 4 panel intersection. One snaps into the top, another at the bottom. $17.95
LC Ajustable legs, will allow you to elevate a panel from ground level up to around 2-3 feet. Usefeul if you are displaying art or other items. These legs are made from commercial grade 1"x2"x.063" rectagular steel tubing, very strong. They simply snap into the sides of the panel. $69 pair. We have several different styles and types, depending upon your specific needs.

Download our installation guide here

LC Office Partition Connectors