The LC E-Panel is equipped with two large square steel 2" x 2" electrical conduits with 6 universal ports (3 on each side of the panel). The ports will accept standard electrical hardware. We can prewire them, or your electrician can supply wiring and outlets to suit your needs. He can run 110 volt or higher voltages if necessary, and he can run telephone, and computer (digital) network wiring, or any combination. These E-Panels will interconnect with standard LC Panels so that you only run your wires where you need them. which enables keeping the costs down.

E Panels carry electrical wiring

Standard E Panels: Up to 4'x6' $219. Larger, up to 4'x10' $249

LC powered office panels can carry power and data lines
Prewired LC E-Panels can accomodate electricity in 2"x2" conduits or raceways. We prewire the lower conduit as shown above using standard male/female electrical plugs on each end. One panel can be "plugged into" the next panel. Once connected, the plugs and wires can be pushed back into the panel conduit for a clean appearance. The upper conduit is usually not wired (by us), and is reserved for low voltage telephone or computer data cabling. Many panels can be connected together this way. The first panel can get power by plugging it into a wall outlet, or extension cord. In a modern world where you may have a wireless router for your computer systems, you may not need the upper conduit. These panels can be made with a single conduit if needed and saves $5 per panel. For prewiring, add $47 per panel.
We have "high low"connectors that will allow you to attach tall panels to shorter ones.
The Standard LC Panel (shown) can actually be connected anywhere along the face of E-Panels by using our T-Connectors.
E-Panels come equipped with standard 7/8" ID holes for wiring. These may be enlarged for bigger wire applications. Two heavy duty square steel conduits 2"x 2" will carry electricity, telephone and digital cable, or any combination.
A typical power pole is a 2" square metal tube. High voltage is run throught the tube. Low voltage like telephone and digital cable generally come "shielded", and can be run through the same tube. If you need a special design, let us know, and we'll try to make it for you. $69 each, up to 10 feet lengths. Taller poles are also available
Power Pole - allows power from the ceiling to enter the LC E panel system.
Email us!
(951) 940 6068 Business, (951) 657 0180 Facsimile
363 W 3rd St., Perris, CA 92570

Large E-panel. This custom E-panel was made for a customer who wanted the conduits to be placed lower in the panel. We noremally place them 16" from the floor but we can actually put the conduits at any height specified by the customer
Standard E Panels: These panels are supplied with single or dual conduits but are not prewired. This way, the end user can have them wired by their electrician for their specific application. The conduits are large at 2"x2" square, and will accomodate very high voltages. Normally, the high voltage is carried in the lower conduit, and low voltage, such as telephone or computer cables are carried in the upper conduit. Any sort of standard electrical hardware should fit the precut conduit ports.
Prewired E Panels: add $47 per panel
Single conduit panels: subtract $5 per panel
Prewired E-Panel with an acryilc window (and protective film) at the top

LC Electric Powered Partition Systems

Sample designs
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8